Yamaha XT225-C Service Manual page 410

Ë Align the end of the brake master cylinder holder
with the punch mark in the handlebar.
Ì Align the slit of clutch lever holder with the punch
mark on the handlebar.
Í Align the end of the handlebar switch (left) with
the punch mark on the handlebar.
Î Route the front brake switch lead and handlebar
switch lead (right) between the handlebar crown
and speedometer, then through the head pipe
guide (left).
CABLE ROUTING
Ï Route the clutch switch lead between the handle
crown and meter and through the head pipe
guide (left).
Ð Clamp the flasher light lead (left), speedometer lead,
main switch lead and handlebar switch lead (left).
Ñ To headlight.
Ò Align the locating tape on the wireharness with
the headlight stay.
Ó Clamp the wireharness.
Ô 10°
- 14 -
SPEC