Polaris RANGER 500 Owner's Manual page 52

OPERATION
BRAKE SYSTEM BREAK-IN
Apply only moderate braking force for the first 50 stops. Aggressive or overly
forceful braking when the brake system is new could damage brake pads and
rotors.
PVT BREAK-IN (CLUTCHES/BELT)
A proper break-in of the clutches and drive belt will ensure a longer life and
better performance. Break in the clutches and belt by operating at slower
speeds during the break-in period as recommended. Pull only light loads. Avoid
aggressive acceleration and high speed operation during the break-in period.
If a belt fails, always clean any debris from the PVT intake and outlet duct and
from the clutch and engine compartments when replacing the belt.
PRE-RIDE INSPECTION
Failure to inspect and verify that the vehicle is in safe operating condition before
operating increases the risk of an accident. Always inspect the vehicle before
each use to make sure it's in safe operating condition.
ITEM
Brake system/pedal travel
Brake fluid
Front suspension
Rear suspension
Steering
Tires
Wheels/fasteners
Frame nuts, bolts, fasteners
Fuel and oil
Coolant level
Coolant hoses
Throttle
Indicator lights/switches
Intake pre-filters
Headlamps
50
REMARKS
Ensure proper operation
Ensure proper level
Inspect, lubricate if necessary
Inspect, lubricate if necessary
Ensure free operation
Inspect condition and pressure
Inspect, ensure fastener tightness
Inspect, ensure tightness
Ensure proper levels
Ensure proper level
Inspect for leaks
Ensure proper operation
Ensure proper operation
Inspect, clean
Check operation, apply POLARIS dielectric
grease when lamp is replaced
PAGE
page 37
page 105
page 105
page 87
page 87
-
page 109
page 109
-
page 87
page 96
-
page 38
page 33
page 44
-
page 112