While Playing - Sony Walkman MZ-N520 Operating Instructions Manual

Net md walkman supplied with new sonicstage 2.0 software
Hide thumbs Also See for Walkman MZ-N520:
Table of Contents

Advertisement

Symptom
"TrFULL" appears
even before the disc
has reached the
maximum recording
time (60, 74, or 80
minutes) and the
recording cannot be
done.
The remaining
recording time does
not increase even
after erasing
numerous short
tracks.

While playing

Symptom
An MD is not
played normally.
An MD is not
played from the
first track.
Playback sound
skips.
Sound has a lot of
static.
The volume of the
recorded track is
low.
Volume cannot be
turned up.
Cause/Remedy
• This is due to the MiniDisc system limitation. When 254 tracks
have been recorded on the disc, "TrFULL" appears regardless of
the total recorded time. More than 254 tracks cannot be recorded
on the disc.
, To continue recording, erase unnecessary tracks.
• This is due to the MiniDisc system limitation. Tracks of under
12 seconds (in SP stereo), 24 seconds (in LP2 stereo mode or
monaural), or 48 seconds (in LP4 stereo mode) in length are not
counted and so erasing them may not lead to an increase in the
recording time.
Cause/Remedy
• Repeat play is selected.
, Use MENU on the recorder to change back to the normal play.
• Playback mode is changed.
, Use MENU on the recorder to change back to the normal play.
• Disc playing stopped before it came to the last track.
, Press N (or NX on the remote control) for 2 seconds or
more to start playing
• The recorder is placed where it receives continuous vibration.
, Put the recorder on a stable place.
• A very short track may cause sound to skip.
, Try not to create a track under one second long.
• Strong magnetism from a television or such device is interfering
with operation.
, Move the recorder away from the source of strong magnetism.
• The track was recorded in analog (When recorded in digital, the
recording level will be automatically adjusted as same as the sound
source), or you used a connecting cord with an attenuator.
, Use a correct connecting cord.
• The recording level was low.
, Adjust the recording level manually when recording.
• AVLS is on.
, Release AVLS settings (page 49).
continued
59

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents