Sony Walkman MZ-N520 Operating Instructions Manual page 19

To
Record from the end of the
1)
current contents
Record over partway
through the previous
1)
recording
Pause
Remove the MD
1)
If "R-Posi" is set to "Fr End
recorded material without pressing the END SEARCH button (page 48).
2)
A track mark is added at the point where you press
the remainder of the track will be counted as a new track.
3)
If you open the lid while "R-Posi" is set to "FrHere", recording will begin from the top of the disc the
next time you record. Check the point to start recording on the display.
If the recording does not start
• Make sure the recorder is not locked (pages
11, 16).
• Make sure the MD is not record-protected
(pages 17, 54).
• Premastered MDs cannot be recorded over.
Notes
• Do not change the rechargeable battery during
operation even if the recorder is connected to
AC power adaptor. The operation may stop.
• "Edit" flashes while data of the recording (the
track's start and end points, etc.) is being
recorded. Do not move the recorder or
disconnect the power source while the
indication is flashing in the display.
• If the power supply is disrupted (i.e. the
battery is removed or becomes exhausted or
the AC power adaptor is disconnected) during
a recording or editing operation, or while
"Edit" appears in the display, it will not be
possible to open the lid until power is restored.
Press
Press END SEARCH, press
1)
T MARK .
or press . or > to find the start point of
Press N
recording, and then press x to stop.
Press N while holding down REC • T MARK.
Press X 2)
.
Press X again to resume recording.
Press x and open the lid.
"Edit" flashing in the display.)
"
, recording operations will always start from the end of the previously
N while holding down REC •
3) (The lid does not open while
X
again to resume recording while pausing; thus
• Note the following when recording from a
portable CD player:
—Some portable CD players may not be
capable of digital out when the AC power
adaptor is disconnected. If this is the case,
connect the AC power adaptor to the
portable CD player and use it on AC power
as the power source.
—On some portable CD players, optical
output may not be possible when using an
anti-skip function (e.g., ESP* or G-
PROTECTION). If this is the case, turn off
the anti-skip function.
Electronic Shock Protection
z
• The recording level is adjusted automatically.
To adjust the level manually, see "Adjusting
the recording level manually" (page 27).
• You can monitor the sound during recording.
Connect the headphones/earphones with
remote control to i and adjust the volume by
turning towards VOL + or – (pressing VOL +
or – on the recorder). This does not affect the
recording level.
19