Messages - Sony MZ-N10 Operating Instructions Manual

Messages

If the following error messages flash in the display window, check the chart below.
Error message
FULL
AVLS
BLANKDISC
BUSY
CannotCHG
Charging
DISC FULL
ERROR
GroupFULL
Hi DC in
HOLD
LINE OUT
90
Meaning/Remedy
• You tried to set a 21st bookmark.
, You can set only up to 20 bookmarks. Keep the number of
bookmarks within 20.
• AVLS is set to "AVLS ON" and so the volume cannot rise higher.
, Set AVLS to "AVLS OFF" (page 68).
• An MD with no recording on it is inserted.
• You tried to operate the recorder while it was accessing the
recorded data.
, Wait until the message goes out (in rare cases, it may take a
few minutes).
• You tried to charge the battery at a place with a temperature
outside the specified range for the recorder.
, Charge the battery at a temperature of 0 C (+32 F) to +40 C
(+104 F).
• The internal battery is being charged.
• The remaining recording time on the disc is 12 seconds (SP
stereo), 24 seconds (LP2 stereo or monaural), 36 seconds (LP4
stereo), or less.
, Replace the disc.
• There is an internal malfunction in the system.
, Restart the operation by doing steps 1 to 3 on page 89. If the
message appears again, please consult your nearest Sony
dealer.
• You tried to create a 100th group.
, You can create only up to 99 groups on a disc. Keep the group
number within 99.
• Voltage of the power supply is too high (The supplied AC power
adaptor or the recommended car battery cord is not used).
, Use the supplied AC power adaptor or the recommended car
battery cord.
• The recorder is locked.
, Slide HOLD against the arrow to unlock the recorder
• You pressed VOL+, – while the "AUDIO OUT" parameter was set
to "LINE OUT".
, Use the jog dial to set the "AUDIO OUT" parameter to
"HeadPhone".
.
(page 20)