Sony MZ-N10 Operating Instructions Manual page 89

Symptom
The recorder does
not work or works
poorly.
The clock does not
work correctly, the
clock does not
appear, or time and
date stamping did
not occur when
recording.
The display
window is not
normal.
When using with
the AC power
adaptor, the display
window of the
recorder will
remain faintly lit
for some time even
after the recorder is
stopped.
The playing time of
a checked-out track
is different from
the time that
appears on your
computer monitor.
Cause/Remedy
• The disc is damaged or does not contain proper recording or
editing data.
, Reinsert the disc. Rerecord the disc. If the error message still
appears, replace it with another disc.
• There is an internal malfunction in the system.
, Remove the recorder from the USB cradle, restart your
computer, and then place the recorder on the USB cradle again.
, Set the BUILT-IN BATTERY switch to OFF, and set back to
ON.
• While operating, the recorder received a mechanical shock, too
much static, abnormal power voltage caused by lightning, etc.
, Restart the operation as follows.
1 Turn off the BUILT-IN BATTERY switch.
2 Leave the recorder for about 30 seconds.
3 Turn on the BUILT-IN BATTERY switch and connect the
power source.
• The built-in rechargeable battery becomes all drained.
, Charge the built-in rechargeable battery, and then set the clock
again.
• The clock is not set.
, Set the clock (page 62).
• The BUILT-IN BATTERY switch is set to OFF causing the clock
to return to its factory setting.
, Set the clock again (page 62).
• Time and date will not be stamped on tracks which are checked out
from a computer.
• The recorder was disconnected from the power source.
, Let the recorder sit for a while, or disconnect the power source,
reconnect it, and then press any of the operation buttons.
• This is due to the MiniDisc system limitation. The recorder turns
off 3 minutes after the recorder has stopped in order to allow the
charging time on the dedicated USB cradle to be calculated.
This is due to a calculation discrepancy between the recorder and
the computer.
89