Too Warm/Too Cold - Viessmann VITOCAL 300 Operating Instructions Manual

Too warm/too cold

If your accommodation is colder/hotter than the room temperature you have
entered, select the menu "Too warm/too cold".
Here you can influence the heat pump or heating circuit curves.
Check before modifying the curve(s), whether the operating mode and
switching times are correctly set.
Only make further modifications using this menu 24 hours later, to take
account of the system inertia.
Adjust characteristic
Set room temperature
.5
Enter current room temperature
The room has
Your room temperature will
change by +2.0
+0.1 0.1
Heat pump/heating circuit settings
Open the programming unit flap and
press the following keys:
1. C
2. A
C
°
3.
4. >>>
5.
+0.1
= 20.0
= 18.0
OK
6. OK
Close the programming unit flap.
for "Programme".
for "Heat pump"
or
for "Mixer 1".
±
/ press until "Too warm/
too cold" is highlighted.
press until the "Adjust
characteristic" menu is
shown with the
required room
temperature.
/ press until the actual
0.1
room temperature is
shown.
The current room
temperature will
already be shown in
the display, if a remote
control unit with room
temperature sensor is
connected.
press to confirm.
The control unit now
calculates a new curve.
Your room temperature
is then matched to the
required value.
19