Before Installation The Air Conditioner; Wireless Remote Control - LG PA11WS Owner's Manual

Before Installation the Air
Conditioner
PREPARING FOR OPERATION
Refer to the Installation Instructions included in
this manual before using the air conditioner.
Once the air conditioner has been properly
assembled and installed:
1
2
3
IMPORTANT
:
• Do not remain in the direct airflow from the air
conditioner for extended periods of time.
• When used at the same time as stoves,
fireplaces, and other combustion devices, make
sure there is a sufficient flow of fresh air into the
room. Do not use in tightly enclosed spaces with
these types of devices.
• This air conditioner is intended for household use
as a consumer comfort appliance. Do not use it
as a precision climate control system, or for
purposes such as cooling precision equipment,
food, pets, plants, artwork, etc. Such items could
be damaged.
• Do not bend the hose downward when window
installation kit is not applied. It may cause failure
of air conditioner or performance deterioration.
UNPACKING THE AIR CONDITIONER
Remove and store packing materials for reuse.
Remove any shipping tape before using the air
conditioner. If the tape leaves behind any adhesive,
rub a small amount of liquid dish soap onto it and
wipe with a damp cloth. Do NOT use sharp
instruments, alcohol, thinners, or abrasive cleaners
to remove adhesive. They could damage the finish.

Wireless Remote Control

Inserting Batteries
If the display screen of the remote control begins
to fade, replace the batteries.
Insert AAA (1.5 V) batteries before using the
remote control.
1
Remove the cover on the back of the remote
control.
2
Insert the new batteries and make sure that the
+ and - terminals of the batteries are installed
correctly.
Operating Method
Point the remote control towards the signal
receiver at the right side of the air conditioner to
operate it.
NOTE
• The remote control may operate other electronic
devices if it is directed towards them. Make sure
to point the remote control towards the air
conditioner signal receiver.
• For proper operation, use a soft cloth to clean
the signal transmitter and receiver.
INSTALLATION
EN
19