General Specification - New Holland TT35 Service Manual

Engine - General specification
TT35 / TT40 models
Make
Type
Power
TT40
TT35
Number of cylinders
Bore
TT40
TT35
Stroke
Cubic capacity
TT40
TT35
Compression ratio
TT40
TT35
Firing order
Idle speed
Maximum no load speed
TT40
TT35
Rated speed
Height of cylinder block between top and bottom faces
Parent bore diameter for cylinder sleeves
Depth of recess of sleeves flange (cast iron sleeves)
Diameter recess of sleeves flange (cast Iron sleeves)
Main bearing parent bore diameter
Camshaft bore diameter number 1
Camshaft bore diameter number 2
Camshaft bore diameter number 3
Engine - General specification
TT45 model
Make
Type
Power
Aspiration
Combustion
Bore (nominal diameter)
Stroke
Cubic capacity
Compression ratio
Rotation
Firing order
Valve tip clearance
Atomiser setting pressure
Inlet valve closes
Exhaust valve closes
Total inlet open period
Engine - Engine and crankcase
4 stroke, diesel, naturally aspirated, direct injection,
3 Cylinder, 4 stroke, inline type, coolant cooled
47899736 29/09/2015
10.1 [10.001] / 3
Simpsons
water cooled
42 Hp (BS Au 141a:1971)
35 Hp(BS Au 141a : 971)
3
91.44 mm (3.60 in)
88.90 mm (3.50 in)
127.00 mm (5.00 in)
2500 cm³ (153 in³)
2400 cm³ (146 in³)
18.5:1
17.5:1
1-2-3
650 - 700 RPM
2200 RPM
2200 RPM
2000 RPM
349.010 - 349.080 mm (13.741 - 13.743 in)
93.660 - 93.690 mm (3.687 - 3.689 in)
3.760 - 3.860 mm (0.148 - 0.152 in)
97.030 - 97.160 mm (3.820 - 3.825 in)
74.080 - 74.100 mm (2.917 - 2.917 in)
47.600 - 47.680 mm (1.874 - 1.877 in)
47.350 - 47.420 mm (1.864 - 1.867 in)
46.840 - 46.910 mm (1.844 - 1.847 in)
Simpsons
47 Hp
Naturally aspirated
Direct injection
95.00 mm (3.74 in)
127.00 mm (5.00 in)
2.70 L (0.71 US gal)
18.3 : 1
Anti-clock wise from the flywheel end
1, 2, 3
0.30 mm (0.01 in) inlet and exhaust
250 - 258 bar (3625 - 3741 psi)
26.8 ° before top dead centre
25.3 ° after top dead centre
250.6 °