MASSEY FERGUSON MF 300 Series Workshop Service Manual page 9

Introduction and Safety in the Workshop
Amendments
Under normal conditions revised pages are issued
carrying the same number as the existing pages requiring
amendment. The new pages are inserted in place of the
existing ones. The old pages should then be destroyed.
The issue number is printed on the bottom of each page,
e.g. Issue 4, 2 or 3 etc.
In some cases additional pages or completely new
sections may be issued. These pages are to be inserted
immediately following the page carrying the next lowest
page number, or section number as appropriate.
Where new pages are required to be positioned between
existing pages, the new page numbers will contain a suffix
MF 300 series
ACT0027090
letter - example: New page number 7 A-16a. This page is
inserted after existing page number 7 A-16 and before
page number 7A-17. Correspondingly a further new page
numbered 7 A-16b would be positioned after 7 A-16a but
before 7A-17.
To ensure that a record of amendments to this manual is
readily available, the list of amendments will be re-issued
with each set of revised pages, quoting the amendment
number, date of issue and appropriate instructions.
NOTE: Service Bulletins and Amendment Sheets are
issued to the Massey Ferguson Distributors and Dealers
only and are not for general circulation.
Find manuals at https://best-manuals.com
1A-3