Table of Contents
Advertisement
f) Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting
edges are less likely to bind and are easier to
control.
g) Use the power tool, accessories and tool bits
etc., in accordance with these instructions and
in the manner intended for the particular type of
power tool, taking into account the working
conditions and the work to be performed. Use of
the power tool for operations different from
intended could result in a hazardous situation.
5) SERVICE
a) Have your power tool serviced by a qualified
repair person using only identical replacement
parts. This will ensure that the safety of the
power tool is maintained.
ADDITIONAL GENERAL SAFETY WARNINGS
Some regions have regulations that restrict the use
of the product. Check with your local authority for
advice.
Never allow children or people unfamiliar with the
instructions to use the product. Local regulations
may restrict the age of the operator.
Ensure before each use that all controls and safety
devices function correctly. Do not use the power
tool if the "off" switch does not stop the motor.
Wear full eye and hearing protection, strong sturdy
gloves as well as head protection while operating
the product; use a face mask if operation is dusty.
Do not wear loose fitting clothing, short trousers or
jewellery of any kind.
Secure long hair so it is above shoulder level to
prevent entanglement in moving parts.
Beware of thrown, flying or falling objects; keep all
bystanders, children, and animals at least 15 m
away from work area.
Do not operate in poor lighting. The operator
requires a clear view of the work area to identify
potential hazards.
Use of hearing protection reduces the ability to
hear warnings (shouts or alarms). The operator
must pay extra attention to what is going on in the
working area.
IMPORTANT SAFETY INSTRUCTIONS
Operating similar tools nearby increases both the
risk of hearing injury and the potential for other
persons to enter your working area.
Keep firm footing and balance. Do not overreach.
Overreaching can result in loss of balance and can
increase the risk of kickback.
Keep all parts of your body away from any moving
part.
Inspect the machine before each use. Check for
correct operation of all controls including the chain
brake.
Check for loose fasteners, make sure all guards,
and handles are properly and securely attached.
Replace any damaged parts before use.
Do not modify the machine in any way or use parts
and accessories which are not recommended by
the manufacturer.
If you need to use an extension cable ensure it is
suitable for outdoor use and has a current capacity
sufficient to supply your tool, check it before every
use for damage, always uncoil it during use
because coiled cables can overheat.
WARNING
If the machine is dropped, suffers heavy
impact or begins to vibrate abnormally,
immediately stop the machine and
inspect for damage or identify the cause
of the vibration.
Any damage should be properly repaired
or replaced by an authorised service
centre.
tool operation, always wear safety goggles or
safety glasses with side shields and a full face
shield when needed. We recommend Wide
Vision Safety Mask for use over eye glasses or
standard safety glasses with side shields.
7
The operation of any tool
can result in foreign objects
being thrown into your
eyes, which can result in
severe eye damage.
Before beginning power
Advertisement
Table of Contents
