Table of Contents
Advertisement
KV-AR25M90B
RM-W104
4-2. CIRCUIT BOARDS LOCATION
4-3. SCHEMATIC DIAGRAM
Note:
All capacitors are in µF unless otherwise noted.
•
•
All electrolytic capacitors are rated at 50V unless otherwise
noted.
•
All resistors are in ohms.
kΩ = 1000Ω, MΩ = 1000kΩ
•
Indication of resistance which does not have rating electrical
power is as follows.
Pitch: 5 mm
Rating electrical power 1/4W (CHIP: 1/10W)
•
: nonflammable resistor.
•
¢
: internal component.
•
: panel designation or adjustment for repair.
•
All variable and adjustable resistors have characteristic curve
B unless otherwise noted.
•
Readings are taken with a color-bar signal input.
no mark
: Common
(
)
: PAL
[
]
: NTSC 3.58
•
Readings are taken with a 10MΩ digital multimeter.
•
Voltage are dc with respect to ground unless otherwise
noted.
•
Voltage variations may be noted due to normal production
tolerances.
•
All voltage are in Volt.
✽
•
: Cannot be measured.
•
Circled numbers are waveform references.
•
: B +bus.
•
: B –bus.
•
k
: signal path.
Note: The reference number which starts with Wxxx
(eg: W003) indicates a wire to wire connection.
Note: Components marked as XX are not fitted on this
model.
C Board
H2 Board
A Board
J1 Board
– 34 –
H1 Board
VM Board
F Board
Reference information
RESISTOR
: RN
METAL FILM
: RC
SOLID
: FPRD
NONFLAMMABLE CARBON
: FUSE
NONFLAMMABLE FUSIBLE
: RS
NONFLAMMABLE METAL OXIDE
: RB
NONFLAMMABLE CEMENT
: RW
NONFLAMMABLE WIREWOUND
: ✽
ADJUSTMENT RESISTOR
COIL
: LF-8L
MICRO INDUCTOR
CAPACITOR
: TA
TANTALUM
: PS
STYROL
: PP
POLYPROPYLENE
: PT
MYLAR
: MPS
METALIZED POLYESTER
: MPP
METALIZED POLYPROPYLENE
: ALB
BIPOLAR
: ALT
HIGH TEMPERATURE
: ALR
HIGH RIPPLE
Note:
The component identified by shading and
mark ! are critical for safety. Replace only
with part number specified.
Note: "A" board schematic diagram is divided into 6 blocks.
Each block is named by its function and block "alphabet".
eg: Processor (Block A)
Joint connection between boards can be identified using
the block alphabet followed by sequence numbering.
eg: -<HOUT-DEFL (A10) To D11
Meaning: Block A joint A10 is connected to Block D joint
D11
Advertisement
Chapters
Table of Contents
