Canon Creative Park Ford Convertible Cabriolet Assembly Instructions Manual

Classic Car Series : 02
Ford
Convertible Cabriolet
Assembly tip
Write the number of each part on the reverse side of the part in pencil upon
cutting it out, to be sure you can tell which part is which later.
Before gluing, crease the paper along mountain and valley fold lines. Trace
along the folds with a ruler and an exhausted ballpoint pen (out of ink) to get a
sharper fold.
Make sure rounded sections are nice and stiff.
Key to symbols
Mountain fold
Dotted line
Valley fold
Dashed and
dotted line
Cut a notch
along this line.
Solid line
Cut a notch
along the line.
Scissors mark
Assembly Instructions : Six A4 sheets (No. 1 to No. 6)
Build this model with careful reference to the Assembly Instructions.
View of completed model * This model was designed for Papercraft and may differ from the original in some respects.
Fold so that the printed pattern faces outside.
Fold so that the printed pattern faces inside.
Cut along the center of the line.
Assembly
Instructions
Tools
Scissors
Ruler, set square
Glue (Wood glue or craft glue recommend)
Exhausted ballpoint pen (out of ink)
Toothpicks (for use in applying glue)
Tweezers (useful for handling small parts)
Pencil
Dots indicate parts to be glued;
Red dot
Glue parts with the same number together.
Green dot
Glue areas within the same part together.
Blue dot
Glue to the reverse side of the specified part.
Blue star
Glue reverse side to reverse side of other part.
Glue, scissors and other tools may be dangerous
to young children so be sure to keep them out of
the reach of young children.
dotted lines indicate approximate area for
application of glue.