Brother 885-V35/V37 Operation Manual page 122

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
UTILITY STITCHES
c Select a stitch.
The stitches that can be used are
41 42 43 44
, , ,
• For details, refer to "Selecting stitching"
(page 51).
Note
When sewing with the wing needle, select a
stitch width of 6.0 mm (15/64 inch) or less.
d Start sewing.
CAUTION
● When sewing with the wing needle, select
a stitch width of 6.0 mm (15/64 inch) or
less, otherwise the needle may bend or
break.
● After adjusting the stitch width, slowly
turn the handwheel toward you
(counterclockwise) and check that the
needle does not touch the presser foot. If
the needle hits the presser foot, the
needle may bend or break.
120
39 40
, ,
45 46 47
, , or .
Partially removing threads is called "drawnwork".
This gives a beautiful result with fabrics that have a
loose weave.
Two ways to create drawnwork are described below.
■ Drawnwork (Example 1)
Pull out several threads from the fabric.
a
Attach monogramming foot "N".
b
• For details on replacing the presser foot, refer
to "Replacing the presser foot" (page 43).
39
c Select stitch .
• For details, refer to "Selecting stitching"
(page 51).
With the right side of the fabric facing up, sew
d
along the right edge of the frayed section.
N