Contec CONPROSYS Alpha Series Reference Manual page 105

LED
Digital input and Input type
Output
(reserved)
Input isolation
Input voltage resistance
The number of input signal channels
Open-circuit impedance
Short-circuit impedance
Response time (digital input)
Interrupt (digital input)
Output type
Output isolation
Output voltage resistance
The number of output signal channels
Maximum output voltage/current
Response time
ON resistance
OFF leakage current
Surge protection element
LED
Connector
Applicable wire
Stack Bus The maximum number of stack buses
LED
Switch (reserved)
RTC
Power supply *3 Rated input voltage
Input voltage range
Power consumption
Connector
Applicable wire
—
Appendix
CPSA-PCB100 Reference Manual
Item
— 105 —
—
Description
Transmission (Green), Reception (Green)
Opto-coupler Isolation Input (Compatible with
current sink output) (negative logic) *1
Opto-coupler Isolation
1000V
4
10kΩ or more
500Ω or less
Within 200μsec
4 interrupt input signals are arranged into a
single output of interrupt signal.
An interrupt is generated at the falling edge
(HIGH-to-LOW transition) or rising edge
(LOW-to-HIGH transition).
(setting can be done by software)
Semiconductor relay output
Semiconductor relay isolation
1000V
4 *usable as digital input or digital output
13.2V/100mA
Within 2msec
8Ω or less (at 25 °C)
4μA or less (at 25 °C)
Interactive TVS Diode
Stand off voltage: ±30V, Peak pulse power :
400W (1ms)
DI0-DI3 (Green)
2-piece 3.81mm pitch 6-pin Terminal
(N.C, DIO3, DIO2, DIO1, DIO0, MCOM)
AWG28 – 16
16 *2
Power (Green)/Status 1(Green) / Status2(Red)/
Error (Red)
Power SW, Rotary SW, DIP SW
RTC built-in (battery within)
24VDC
21.6 – 26.4VDC
Controller alone: 24V 0.3A (Max.)
With module(s): 24V 3.6A (Max.)
2-piece 3.5mm pitch 3-pin terminal (V+, V-,
FG)
AWG20 – 16