Settings For Audio Out; Installation; Installation And Safety Notices - Blaupunkt IVSC-3302 Operating And Installation Manual

IR REMOTE CONTROL

Settings for Audio OUT

; AUDIO CH • Arrow button
Select the input source for Audio
OUT.
Note: The volume of the input
source must be adjustable.
< BOOSTER
Setting the amplification for Audio
OUT /
12
/
0 dB or 10 dB.

Installation

Installation and safety notices

Before connecting your signal control-
ler, please read the following informa-
tion carefully.
The battery's negative terminal must
be disconnected for the entire time it
takes to install and connect this device.
When doing so, observe the vehicle
manufacturer's safety notices (airbags,
alarm systems, trip computers, immo-
bilizers).
Before drilling any holes, make sure that
no installed cables or vehicle compo-
nents can be damaged.
When installing the signal controller,
select a location in the vehicle that al-
lows you to attach it firmly into place
using screws. The installation location
should be such that the signal control-
ler does not get in the way of the driver
and cannot endanger the occupants in
the event of the vehicle suddenly com-
ing to a halt, for instance, during an
emergency stop.
The IR remote control should not be in-
stalled within the inflation range of air-
bags (driver, passenger side, side air-
bags) or in any position where it could
be struck by the vehicle occupants'
heads or knees.
With regard to the installation location
and the attachment using an adhesive
pad, check and ensure that the holding
strength of the installation surface is
sufficient and suitable for all situations
and safety requirements.
INSTALLATION