Cleaning The Pre-Motor Filter - Bissell ZING 10M2 Series User Manual

M
aintenance and care

Cleaning the pre-motor filter

The pre-motor filter protects
the motor from dirt and dust
particles. Use only BISSELL
replacement filters in your Zing
1. Remove the dirt cup from the vacuum,
following steps 1-3 of Emptying the
dirt cup on page 8.
2. The pre-motor filter is located between
the power button and the automatic
cord rewind button.
3. The pre-motor filter can be hand
washed in cold water with a mild
detergent. Rinse well and air dry
completely before placing back into
the vacuum.
10
w w w . b i s s e l l . c o m
NOTICE:
This product is intended for house-
hold use only and not for commer-
cial or industrial use. Vacuuming
of dust from products like plaster,
concrete or ashes will damage the
motor and void the warranty.
3.
Washable
Pre-Motor
Filter
Tip:
For maximum cleaning
performance, check the
filters often and clean or
replace if necessary.
8 0 0 . 2 3 7 . 7 6 9 1