Cleaning The Pre-Motor Filter - Bissell CLEANVIEW 59M5 User Manual

M
aintenance and care

Cleaning the pre-motor filter

The pre-motor filter protects the
motor from dirt and dust particles.
1. Unplug the vacuum from electrical outlet.
2. Open the dust bag compartment by
lifting up on the latch on the door at
the front of the vacuum. Lift out the
dust bag holder and dust bag.
3. Remove the filter frame from the
filter holder by grasping the lip of the
frame and pulling up.
4. Remove the filter from the filter frame
and clean by hand washing in warm
water. A mild detergent can be used if
desired. Allow the filter to air dry
thoroughly before replacing.
5. Place the filter back into the filter
frame and replace back into the f
ilter holder.
NOTE: The filter frame should be
placed so the protective frame is
visible.
6. Place dust bag holder and dust back
into the dust bag compartment, making
sure the entire bag is tucked in below
the seal gasket.
7. Close dust bag compartment door
and press down gently until it locks
into place.
w w w . b i s s e l l . c o m
NOTICE:
This product is intended for house-
hold use only and not for commercial
or industrial use. Vacuuming of dust
from products like plaster, concrete
or ashes will damage the motor and
void the warranty.
Washable Pre-Motor Filter
3.
Tip
For maximum cleaning
performance, check the
filters often and clean or
replace if necessary.
WARNING:
Do not operate cleaner
with damp or wet filters
or without all filters in
place.
11