Panasonic SC-PMX802 Operating Instructions Manual page 16

S
л
Initialisation
Reset the memory w'hen the following situations occur:
• There is no response w'hen buttons are pressed.
• You want to clear and reset the memory contents.
1
W ait 30 seconds before you continue with step 2.
2
Keep holding dow'n [Ф /І] until "--------------" appears on
the display.
3 [Ф /І].
All the settings are set back to the factory default.
It is necessary to set the memory items again.
To reset the netw'ork settings, perform the operation for
network reset, ( o 6)
Remote control code
When other Panasonic equipment responds to the
remote control of this system, change the remote control
code for this system.
1 P ress [S E L E C T O R , - F 0 IR IN G ] on the main
2
3
• The factory default is "R E M O TE Г .
• To change the mode back to "RE M O TE T , repeat the
steps above but replace the button pressed on the
remote control from [2] to [1].
>