Table of Contents
Advertisement
m
. Depending on your system configuration, messages
instructing you to "Press Any Key" may appear. These
are BIOS messages from installed option boards. Before
pressing a key, you should consult the manual of the
option board.
. If you install a new option board in a PCI slots, remove
an existing board, or reinstall boards in different slots,
POST may stop running after displaying a message to
the effect that the configuration of the installed boards is
incorrect.
If this occurs, press the <F1> key to restart POST, and
use the BIOS Setup Utility to set or change the board
configuration.
DMW-S01NL/S02NL/ST001
3. Main Unit Power Off
Proceed as follows to power the Main Unit off.
If you have connected the power cord to a UPS (uninter-
ruptible power supply) or other power regulator, refer to
the manual supplied with the UPS or to the documentation
of the application controlling the UPS for information
about powering off.
(1) Shut down Windows 2000.
(2) Power peripherals off.
1-9. System Initial Setup
1-37
Advertisement
Table of Contents
