Operation - Honeywell HPA020 Series Owner's Manual

INSTALL CERTIFIED HEPA FILTERS AND ODOR REDUCING PRE-FILTER
The Certified HEPA Filter and Odor Reducing Pre-Filter are supplied
within your air purifier. New air purifiers have their filters wrapped to
ensure purity and are labeled to help identify the proper replacement
filter (Type Certified HEPA Filter and Type
G
Filter
Pre-Filter).
• Before using your new air purifier you must remove the wrappers
covering the filters and pre-filter. Make sure the air purifier is OFF
and unplugged.
• Turn the air purifier upside down on a flat surface. The filter is
visible from the bottom of the unit (Fig. 2).
• Remove the Certified HEPA Filter by grasping the filter from the
finger notches. There are small molded tabs that secure the filter
in place and prevent it from slipping out of the unit. Pull away from
tabs and up to remove. When removing a used filter that is not wrapped in plastic, pull the red tab to remove.
• Remove the protective plastic wrap from the HEPA Filter and Pre-Filter.
• Install the Pre-Filter first by sliding it in behind the front grille of the air purifier and securing it in the molded slots.
• Install the Certified HEPA Filter by sliding it in the opening on bottom of the air purifier. Ensure that the red tab
is accessible for easy removal.
WARNING: Filters may be harmful if ingested. Avoid breathing dust when changing filters.

OPERATION

• Ensure the air purifier is plugged into a working
electrical outlet
• Turn the Power Knob to desired setting
(O = Off, III = High, II = Medium, I = Low)
Portable air purifiers are more effective in rooms
where all the doors and windows are closed. It is
recommended that you run your air purifier while
you are at home to help clean the air.
Odor Reducing
A
Pre-Filter
The energy efficiency of this ENERGY
STAR certified model is measured
based on a ratio between the model's
CADR for Smoke and the electrical
energy it consumes, or CADR/Watt.
Power ON LED
Cleaning
Levels
Power Control
Knob
4
Molded tabs
secure filter
Fig. 2
Check Filter
Indicator
Light
FILTER
RESET
Button
Fig. 3