Table of Contents
Advertisement
3 - 2 2
GROUP
3-SUSPENSION,
STEERING, WHEELS
AND TIRES
IN-CAR ADJUSTMENTS AND REPAIRS
P U M P BELT T E N S I O N
ADJUSTMENT
Pump drive belt tension cannot be
checked accurately using the thumb
pressure o r belt deflection methods.
Correct belt adjustment is assured
only with the use of a belt tension
gauge.
1. Check the belt tension with a
gauge. With a new belt, o r one that
has been run for less than 15 min-
utes, the tension should be within
120-150 lbs. With a belt that has been
run for more than 15 minutes, the
*
tension should be within 90-120 lbs.
2. T o adjust the belt, loosen the
pump pivot and adjusting bolts to
allow movement of the bracket in its
adjusting slot. Move the pump as
req&red, and snugly tighten the bolts.
Do not move the pump by lifting
or pulling on the reservoir.
3. Recheck the belt tension. When
the tension has been correctly ad-
justed, tighten the bolts to 22-28 ft-
lbs torque.
FILTER REPLACEMENT
1. Remove the cover from the
power steering pump o r reservoir
and remove the gasket. Clean the
gasket surface.
2. Remove the fluid with a suction
gun.
3. Lift the hold-down spring, wash-
e r and the filter element from the
reservoir.
4. Wipe the reservoir clean with a
lint-free cloth.
5.
Position a new filter unit on the
seat (Fig. 4 ) .
6. Cement (M2G14-A) a new
cover gasket around the inside of the
cover.
7. Position the retaining washer
and the hold-down spring on the
filter element.
8. Install the cover and gasket. On
units equipped with remote mounted
reservoir, turn the wing nut down
until it is flush with the top of the
SPEED-UP CONTROL
stud.
9. Fill the reservoir and check for
leaks.
10. Recheck the fluid level and re-
plenish the fluid as required.
FIG. 3-Power Steering Idle Speed Control Valve
FIG. 4-Fluid Reservoir
REMOVAL AND INSTALLATION
STEERING GEAR
Refer to Group 3-3, Section 3 for
detailed instructions.
P O W E R STEERING P U M P
REMOVAL
1.
Remove the fill cap from the
reservoir and remove the fluid with
a suction gun.
2. Disconnect the fluid return hose
from the reservoir.
3. Disconnect the oil pressure line
from the pump.
4. Disconnect the idle speed-up
valve line from the pump.
5.
Loosen the belt adjusting bolt
and the pivot bolt. Remove the drive
belt from the pump pulley.
6. Remove
the power
steering .
pump-to-bracket attaching bolts, then
lift the pump from the engine.
INSTALLATION
1. Secure the power steering pump
to the bracket with the attaching
bolts, but d o not tighten the bolts at
this time.
2. Position the drive belt on the
power steering pump pulley and on
the crankshaft pulley.
3. With Tool T62L-8620-A in-
stalled o n the pump drive belt, raise
the pump to obtain the specified belt
tension, then tighten the adjusting
bolt.
4. Tighten all of the pump attach-
ing bolts at this time.
5.
Connect the oil pressure line
and the idle speed-up line to the
Pump.
6. Connect the oil return line to
the reservoir.
Advertisement
Table of Contents
