Opearting Instructions; Inserting Batteries - Vitek VT-3504 BK Manual Instruction

CLOCK RADIO
DESCRIPTION
1 – Projector
2 – BAND switch (FM/АМ)
3 – SNOOZE/SLEEP button
4 – radio on/off button
5 – AL.1 button
(choosing a signal for alarm 1)
6 – AL.2 button
(choosing a signal for alarm 2)
7 – LINE IN jack
8 – RESET button
9 – FOCUS control
10 –180° FLIP button
11 –PROJECTION ON/OFF button
12 – Temperature sensor (indoor only)
13 – FM-antenna cord
14 – Power cord
15 – AL.SET button (setting and viewing the alarm
actuation time)
16, 17 –<</>> buttons (parameters changing)
18 – MODE switch
19 – DIMMER
20 – Display
21 – VOLUME ± control
22 – TUNING knob
23 – Battery compartment lid
24 – Speaker
ATTENTION!
rISK OF ELECTrIC SHOCK
DO NOT OPEN
Warning: To prevent fire or shock hazard do not
expose the appliance to rain or moisture.
To prevent shock hazard do not remove the cover
yourself. Apply to a service centre for repair and
maintenance.
This lightning flash with arrowhead
symbol, within an equilateral triangle, is
intended to alert the user to the presence
of uninsulated "dangerous voltage" within
the product's enclosure that may be of
sufficient magnitude to constitute a risk of
electric shock to persons.
The exclamation point within an equilateral
triangle is intended to alert the user to
the presence of important operating and
maintenance (servicing) instructions in the
manual accompanying the appliance.
Please read these instructions carefully before con-
necting, operating or adjusting the unit.
3504IM.indd 3
Follow all warnings and operating recommendations
contained in this manual.
Keep this manual for future reference.
PRECAUTIONS
• Check whether the electricity supply in your home
sockets corresponds to the voltage specified on
the housing of the unit.
• In order to avoid risk of fire or electric shock, do
not subject the unit to rain or moisture. Do not
place containers with water, for instance vases,
on the unit.
• Do not immerse the unit into water. To prevent
fire or shock hazard, do not use this unit in high
humidity conditions (near a bath tub, wash bowl,
kitchen sink or laundry washer, in a wet base-
ment, or near a swimming pool, etc.) Prevent the
unit from dripping and splashing.
• Do not overload wall outlets or extension cords as
this can result in a risk of fire or electric shock.
• Place the unit in a way that you could easily pull
the plug out of the socket if there are some dam-
ages.
• For additional protection during lighting and in
cases when you are not going to use the unit for
a long time, unplug the unit. It will prevent the unit
from failure during lighting and power surges.
• To unplug the unit, hold its plug. Do not pull the
cord.
• In order to avoid electric shock do not remove the
cover yourself. Do not repair and do not modify
the unit. Technical maintenance must be per-
formed only by qualified service personnel.
• Install the unit in places with proper ventilation.
Do not block the ventilation openings of the unit.
• Do not connect the FM-antenna with the external
antenna.
• The product should be situated away from heat
sources such as radiators, heat registers, stoves,
or other products that produce heat. Do not ex-
pose the unit to direct sunlight, excessive dust,
vibration or mechanical shocks. Do not place the
unit near sources of open fire, such as candles.
• Provide that foreign object do not get in the open-
ings of the unit.
• Close supervision is necessary when the unit is
used by children or disabled persons.
• Keep the unit out of reach of children.
• Do not allow children to use the unit as a toy.

OPEARTING INSTRUCTIONS

Inserting batteries

• Open the battery compartment lid and insert a 3V
Cr2032 battery (not supplied), following the po-
larity.
• Close the battery compartment lid.
3
ENGLISH
22.10.2013 16:37:18