18. ENVIRONMENTAL CONCERNS..............37 FOR PERFECT RESULTS Thank you for choosing this AEG product. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler – features you might not find on ordinary appliances. Please spend a few minutes reading to get the very best from it.
ENGLISH SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damage that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference.
This appliance is intended to be used in household • and similar applications such as: staff kitchen areas in shops, offices and other – working environments; by clients in hotels, motels, bed & breakfast and – other residential type environments;...
Page 5
ENGLISH future they must be reattached to lock • Make sure not to cause damage to the drum to prevent an internal the mains plug and to the mains damage. cable. Should the mains cable need to • Always take care when moving the be replaced, this must be carried out appliance as it is heavy.
2.4 Use valves, filters and aquastops, printed circuit boards, electronic displays, WARNING! pressure switches, thermostats and Risk of injury, electric shock, sensors, software and firmware fire, burns or damage to the including reset software, door, door appliance. hinge and seals, other seals, door locking assembly, plastic peripherals •...
ENGLISH 3.2 Appliance overview 11 12 Worktop Drain hose Detergent dispenser Inlet hose connection Control panel Mains cable Door handle Transit bolts Rating plate Hose support Drain pump filter Feet for levelling the appliance The rating plate reports the model name (A), product number (B), electrical ratings (C) and serial number (D).
Level of protection against ingress of solid particles and IPX4 moisture ensured by the protective cover, except where the low voltage equipment has no protection against mois‐ ture Water supply pressure Minimum 0.5 bar (0.05 MPa) Maximum 8 bar (0.8 MPa)
Page 9
ENGLISH 5.3 Positioning and levelling WARNING! It is possible to see 1. Install the appliance on a flat hard water flowing from the floor. drain hose. This is because the washing Make sure that carpets do machine has been not stop the air circulation tested at the factory.
Page 10
WARNING! The inlet water shall not exceed 25 °C. CAUTION! Make sure that there are no leaks from the couplings. Do not use an extension hose if the inlet hose is too short. Contact the service 5.4 The inlet hose centre for the replacement of the inlet hose.
Page 11
ENGLISH 5. Without the plastic hose guide, to a sink spigot - Put the drain hose in the spigot and tighten it with a clamp. Refer to the illustration. Make sure that the drain hose end is not immersed in the water.
If you install the appliance on a plinth WARNING! that is not an accessory supplied by Do not put the tumble dryer AEG, secure the appliance in the fixing under the washing machine. plates. Verify the compatible stacking kit by checking the Read carefully the instructions supplied depth of your appliances.
The digital indicator can show: • Programme duration (e. g. • Delay time (e. g. • Cycle end ( ). • Warning code ( Extra rinse indicator. It lights on when this option is se‐ lected . indicator blink during the laundry load detec‐...
Page 15
ENGLISH containing sand, dust , mud and other The appliance empties the solid particles. water out automatically after 18 hours approximately. This option can increase the programme duration. Activate the No Spin option • Rinse only The appliance performs only the •...
9. PROGRAMMES 9.1 Programme Chart Washing programmes Programme Programme description Washing programmes Eco 40-60 White cotton and fast-coloured cotton. Normally soiled items. The energy consumption decreases and the time of the washing programme is extended, ensuring good washing re‐...
Page 17
ENGLISH Programme temperature, maximum spin speed and maximum load Programme Default temper‐ Reference spin Maximum load ature speed Temperature Spin speed range range Washing programmes 1400 rpm Eco 40-60 10 kg 40 °C 1400 rpm - 800 rpm 40 °C 1400 rpm 10 kg Cottons...
ENGLISH ▲ = Recommended -- = Not recommended 9.2 Woolmark Apparel Care - Blue The wool wash cycle of this machine has been approved by The Woolmark Company for the washing of wool garments labelled as «hand wash» provided that the garments are washed according to the instructions issued by the manufacturer of this washing machine.
12. DAILY USE 12.3 Filling the detergent and WARNING! additives Refer to Safety chapters. 12.1 Activating the appliance 1. Connect the mains plug to the mains socket. 2. Open the water tap. 3. Press the button for a few seconds to activate the appliance.
Page 21
ENGLISH 12.4 Check the position of the With the flap in the flap position DOWN: • Do not use gelatinous 1. Pull out the detergent dispenser until or thick liquid it stops. detergents. 2. Press the lever down to remove the •...
Page 22
12.6 Starting a programme 12.8 The ProSense load with the delay start detection Touch the Start/Pause button. The programme duration in The appliance starts the countdown of the display is referred to a the delay start. medium/high load. When the countdown is completed, the programme starts.
Page 23
ENGLISH 12.9 Interrupting a In the display the related door lock indicator goes off. programme and changing the options When the programme is running, you can change only some options: 1. Touch the button Start/Pause. The related indicator flashes. 2. Change the options. The given information in the display changes accordingly.
4. Keep the door and the detergent In any case, the appliance dispenser slightly ajar to prevent empties the water out mildew and odours. automatically after 5. Close the water tap. approximately 18 hours. 12.13 Draining water out after 12.14 Stand-by option...
Page 25
ENGLISH • Do not wash laundry without hems or programmes (60 °C max) for all with cuts. Use a washing bag to wash types of fabric, or special ones for small and/or delicate items (e.g. woollens only. underwired bras, belts, tights, •...
Refer to 'Water additive for water softening. In areas hardness'. where the water hardness is soft it is not • Set the maximum possible spin necessary to use him. speed for the selected washing To find out the water hardness in your programme before drying your area, contact your local water authority.
Page 27
ENGLISH 14.4 Descaling Clean it when needed, using ammonia cream cleanser agent without scratching If the water hardness in your the seal surface. area is high or moderate, we Always obey the instructions recommend that you use a that you find on the water descaling product for packaging of the product.
Page 28
4. Insert the detergent drawer into the accumulated detergent. After guide rails and close it. Run the cleaning, put the top part back into rinsing programme without any position. clothes in the drum.
Page 29
ENGLISH Proceed as follows to clean the pump: 180˚ WARNING! Make sure that the impeller of the pump can rotate. If it does not rotate, contact the Authorised Service Centre. Make sure also that you tighten the filter correctly to prevent leakages.
Page 30
14.10 Cleaning the inlet hose right (not in vertical position) depending on the position of your and the valve filter water tap. It is recommended to clean both the filters of the inlet hose and valve occasionally to remove any deposit, collected over the time: 1.
ENGLISH 15. TROUBLESHOOTING WARNING! Refer to Safety chapters. 15.1 Alarm Codes and Possible failures The appliance does not start or it stops during operation. First try to find a solution to the problem (refer to the tables). WARNING! Deactivate the appliance before carrying out any check. With some problems, the display shows an alarm code and the Start/Pause button may flash continuously: Problem...
Page 32
• Wait until mains supply is stable. The mains supply is unstable. • Disconnect the appliance and close the water tap. Contact the Authorised Service Centre. The anti-flood device is on. If the display shows other alarm codes, deactivate and activate the appliance.
ENGLISH Problem Possible solution • Make sure the levelling of the appliance is correct. Refer to The appliance makes "Installation instruction". an unusual noise and • Make sure that the packaging and/or the transit bolts are re‐ vibrates. moved. Refer to "Installation instruction". •...
Page 34
The QR code on the energy label supplied with the appliance provides a web link to the information related to the performance of the appliance in the EU EPREL database. Keep the energy label for reference together with the user manual and all other documents provided with this appliance.
ENGLISH 16.4 Common programmes These values are indicative only. Programme Litres h:mm °C Cottons 2.90 4:05 1400 95°C Cottons 1.80 3:40 1400 60°C Cotton 20° 0.40 3:15 1400 20°C Synthetics 0.85 2:30 1200 40°C Delicates 0.35 1:25 1200 30°C Wool/Silk 0.30 1:05 1200...
Page 36
2. Set the desired options (1) by means Push the On/Off button to turn the of the corresponding touch buttons. appliance off. To start the programme, touch the Start/Pause (2) button. 3. The appliance starts. At the end of the programme, remove the laundry.
ENGLISH Programmes Load Product description All fabrics, except woollens and very delicate 10 kg fabrics. Programme for spinning and draining Spin/Drain the water. 1) Tested for Staphylococcus aureus, Enterococcus faecium, Candida albicans, Pseudomonas aerugino‐ sa and MS2 Bacteriophage in external test performed by Swissatest Testmaterialien AG in 2021 (Test Report No.