Controls And Switches - Yaesu FT-101ZD Instruction Manual

( 1 ) MODE
Selection of LSB, USB, CW-W (SSB filter) , and
CW-N (optional CW filter) is provided.
(2) WIDTH ON
When this button is pressed , the variable bandwidth
fun ction is activated.
(3)
WIDTH
This control varies the IF bandwidth from 2 . 4 kHz
down to 300 Hz. When the WIDTH swit ch is OFF,
t he bandwidth is fixed by the filter selected at the
MODE swit ch .
( 4 ) SELECT switches
When using the optional FV-90 I DM synthesized ,
scanning external VFO, these swit ches determine
which component will control
receive , or transceive frequency .
EXT . . . . . . This swit ch,
control of the transceive frequency to
the external VFO .
TX EXT . . . This swit ch,
control of the transmit frequency to
the external VFO .
RX EXT . . . This swit ch,
control o f the receive frequency to
the external VFO.

CONTROLS AND SWITCHES

the transmit ,
when pressed , shifts
when presse d , shifts
when pressed , shifts
-4-
VFO . . . . . . This swit ch selects control o f the
transceive frequency on the FT- 1 0 I ZD
internal VFO .
CH I , CH2 . . These swit ches select optional fixed
channels, transceive only .
( 5 ) PRESELECT
The preselector control peaks the RF and IF stages
for the frequency in use .
( 6 ) BAND
The bandswit ch selects the frequency b and in use :
1 60 - 1 0 m eters , plus WWV/JJY 5 MHz.
(7)
CLARIFIER
The clarifier control allows o ffset o f
from the frequency established by the m ain tuning
dial.
( 8 ) ( 9) CLARIFIER SELECT switches
Press the RX button for offset of the receive
frequency .
Press the TX button for offset o f the transmit
frequency .
Press both buttons for offset o f the transceive
frequency .
±
2 . 5 kHz