3. Short two points of jumpers (A). (Figure 5-4)
A
Figure 5-4. CMOS Jumper
Table 5-3. CMOS Jumper
Item
Description
CLRP1
Clear CMOS Jumper
4. Plug in AC adapter.
5. Press Power button until BIOS POST is finished
6. Remove conductivity tool from RCT_RST point.
7. Restart the system and press F2 to enter BIOS Utility Setup menu.
8. If no password prompt is shown, BIOS password is cleared.
9. If password prompt is shown, repeat steps 1 through 9.
5-6
Jumper and Connector Locations