Garmin REACTOR 40 KICKER Installation Instructions Manual page 12

Installing the Steering Actuator in the Tilt Tube
1 Apply white lithium grease to the push rod on the steering actuator.
2 Starting from either side, feed the steering actuator into the tilt tube.
3 Screw the steering actuator onto the end of the tilt tube.
4 Rotate the steering actuator until the connector is facing the best direction for your installation.
5 Using the included 5 mm hex wrench, tighten the screw to prevent the steering actuator from rotating on the
tilt tube.
6 Slide the seal onto the other end of the steering actuator, and rotate it clockwise to attach it to the tilt tube.
12