Fitting Into The Cabinet - AEG COMPETENCE D4100-1 Operating Instructions Manual

FITTING INTO THE CABINET

IMPORTANT: Ensure that the oven is
switched off at the wall before any
further work is carried out.
Using a tape measure establish the internal
width of the cabinet. Refer to page 41 if greater
than 565mm.
Position the appliance in front of the cabinet.
See Fig. 8.
Take out all oven furniture before installation to
reduce the weight you need to lift. The oven
door should be taped up to keep it closed whilst
lifting.
To place the appliance into the cabinetry follow
the procedure below:
N.B. Two people will be required to carry
out the lifting procedure.
Warning: Do not attempt to lift this
appliance by the handle(s).
Each person should squat either side of the
appliance.
Tilt the appliance so that your hands can
support the underside of the appliance.
Keeping your back straight, raise the appliance
to the cabinet by straightening at the knees.
Rest the rear underside of the appliance on the
cabinet floor while your hands support the front.
The appliance can be pushed fully into the
cabinet. Take care to avoid damaging the
mains lead.
Ensure the appliance is central in the cabinet
and level.
Do not remove spacer fitted behind fixing
holes.
When the appliance is fully housed screw the
stability screws (supplied with the appliance)
into the side of the cabinet taking care not to
distort the side trims (See Fig. 9). It is advisable
to turn each screw alternately to avoid
damaging the trims.
Switch on the appliance then refer to the
operating instructions.
COMPETENCE D4100-1- 311570606
46
(Cable not supplied)
Fig.8
Fig.9