Advertisement
5.3 Heating 1 and Heating 2
In this operating mode you can set the desired temperature
by pressing the + and - adjustment buttons (B).
Heating 1 (minimum power level):
-
The appliance operates at the minimum power, reducing
noise and energy consumption to the minimum.
-
Heating 2/BooSt function (maximum power
level):
The appliance operates at the maximum power for rapid
heating of the room.
6. Eco function
In this operating mode the appliance will automatically set
the power level to guarantee the best comfort reducing the
energy consumption. In this operating mode the unit may
switch the heating power level from maximum to minimum
and viceversa, several times in an hour. When using the ECO
function, the maximum temperature setting is 79°F (26°C).
To activate this function, press the ECO button (D).
7. If you want the appliance to distribute the airflow over
a larger area, press the oscillation button (C)
appliance will then oscillate right and left. To stop the
oscillation in the desired position, just press oscillation
button (C) again.
8. To turn off the appliance press button ON/OFF (A). The
display will show a count down for about 6 seconds.
note: The display can show the temperature in both °F and
°C. To change the temperature scale, press and hold the + key
for few seconds, then release.
Please be informed that as this is not a precision device, the
showed temperature not necessary corresponds to the real
one.
24 h digital timer
This function can be activated from any operating mode.
delayed switch-on: with the appliance in the OFF position,
press the timer button (E )
and the time remaining before switch-on. To set the
timer, use the + and - adjustment buttons (B), then wait a
few seconds for the programming to be set.
The display shows the symbol
the timer. When the programmed time has been reached, the
appliance turns on with the same settings it had during the
previous operation.
Auto-off: with the appliance on, press the timer button (E)
.
The display shows the symbol
before shut-off. To set the timer, use the + and - adjustment
buttons (B), then wait a few seconds for the programming to
be set. The display returns to show the current settings and
use/Maintenance/Warnings
. The
. The display shows the symbol
to indicate you have set
and the time remaining
the symbol
to indicate you have set the timer. When the
programmed time as been reached the appliance shuts off
automatically. If you want to go back to operation without
the timer, press the timer button (E) twice. The timer symbol
disappears from the display.
using the remote control
The remote control functions correspond to those on the
control panel. See the section "Operation and Use" on the
previous page for a description of the functions.
Inserting or replacing the batteries
-
The remote control is
provided with a lithium
battery CR2032. To let
the appliance function,
remove the battery
cover strip, by pulling it.
-
To replace the batteries,
remove the battery
cover by rotating it.
Replace the battery paying attention to respect the right
polarity as shown in figure 2.
-
Replace the cover rotating it towards the position
"CLOSE".
-
Old batteries must be removed and disposed off in
accordance with current legislation as they are harmful
to the environment.
MAIntEnAncE
-
Before carrying out any maintenance, always remove
the plug from the power outlet.
during the season when the appliance is being
-
used, regularly clean the air intake and outlet
grilles using a vacuum cleaner.
-
Never use abrasive powders or solvents to clean the
appliance.
-
Remove the back grille by pulling it outward (Fig. 1).
-
Remove the dust filter that filters impurities from the air
taken in from the room, blow it lightly, then reposition
it in the appliance.
WArnInGS
-
Never use this heating appliance in the immediate
vicinity of a bathtub, shower, or swimming pool.
-
Use the appliance always and only in the vertical
position.
-
Do not use the appliance to dry laundry, and do not
obstruct the air intake and outlet grilles (danger of
overheating).
-
Do not operate the appliance in contact with walls,
6
en
battery
cover
battery
Fig. 2
Advertisement
