Sharp LC-60LE831U Service Manual page 58

LC-40/46/52/60LE835U/830U/832U/LC-60LE831U
11. Factory setting
After completing the factory setting, pull out the AC cord to complete the setting.
CAUTION: Do not turn on the power after completing the factory setting. If the power is turned on, configure the factory setting again.
Adjustment point Adjustment conditions
1 Factory setting Complete the setting by
pulling out the AC cord.
12. Software version
1. Main microcomputer
2. Monitor microcomputer
3. EDID data (Analog RGB)
4. (Reference: File name in the Technical Department)
For analog RGB Input3: IC509: edid_dsub15_fullhd_v6_256_fix.BIN
13. An anti-crosstalk measure at the time of the low temperature
• It is a function to control a picture gain depending on the value of the thermistor on the board to reduce crosstalk at the time of the low tempera-
ture.
• The value of the thermistor is confirmed in "TEMPERATURE" of 1/27 pages menus in a process.
• When change the parameter of this function, turn on "CROSSTALK ADJ MODE" of 23/27 pages menus in a process.
• The other parameters of 23/27 pages menus support the following graph in a process.
• For a function to control a picture gain, a screen darkens depending on setting.
• Because the most suitable value is set by default, please do not usually change it.
CROSSTALK GAIN1
CROSSTALK GAIN2
CROSSTALK GAIN3
•Point the cursor to [INDUSTRY INIT], set to "ON" using [+]/[-] of the [VOL] key, and press
the [ENT] key.
The version confirmation screen appears on the green screen. It is completed when [SUC-
CESS] is displayed at the top.
(If error occurs, [ERROR] is displayed on the red screen.)
•Turn off the AC power.
The following items are initialized when configuring the factory setting.
1) User set value
2) Channel data (broadcasting frequency, etc.)
3) Password setting value
4) Operating time
5) StandbyCause
6) Auto installation flag
7) V-CHIP block setting value
CROSSTALK TH4 CROSSTALK TH2
CROSSTALK TH3
5 – 15
Adjustment procedure
(A thermistor value)
CROSSTALK TH1