Table of Contents
Advertisement
NOTE:
In the example provided, eno4 is selected as the management interface for the VEP1405 series device.
7.
NOTE:
If DHCP is not being used, from the Interface configuration screen, modify the interface configuration for
static IP assignment.
From the Interface configuration screen, modify the interface configuration for static IP assignment.
Figure 16. Choose edit IPv4
NOTE:
In the example provided, the Edit IPv4 option is selected.
8. Within the IPv4 configuration screen, enter the required Subnet, Address, Gateway, and Name server in the fields
provided, then select Save.
9. Click Done to apply the network configuration the changes.
10. From the Configure the interface server, proxy connection settings, and alternate mirror configuration screens,
select Done to continue.
11. Within the Filesystem setup screen, locate and select the Use An Entire Disk And Set Up LVM option.
12. When prompted to select the disk to install to, select SATA Flash Drive and then select Done.
13. From the Confirm destructive action screen, select Continue to proceed with the disk partition.
14. In the fields provided, enter the required Name, Server name, and User name, then select Done.
15. Review the snaps information that is provided and select Done to start the installation process.
Figure 17. Server environment snap listing
16. After the installation process is complete, remove the USB drive from the device then select Reboot Now.
Configure BIOS to boot from SSD
The information in this section provides the instructions for configuring the BIOS to boot from the SSD.
1. From the BIOS screen, use the arrow keys to select the Boot tab and press Enter to change the boot option priority.
2. Using the arrow keys, change the Boot Option filter to SATA Flash Drive and then press Enter.
16
Configure BIOS and install Ubuntu 18.04 operating system to SSD
Advertisement
Table of Contents
