Repair; Replacing The Datatrak Battery - Graco EcoQuip 2 Vapor Abrasive Blast System Operation, Repair, And Parts

Repair

Repair Repair Repair
Replacing the the DataTrak DataTrak Battery
Replacing Replacing the DataTrak
FIRE FIRE AND FIRE AND EXPLOSION AND EXPLOSION HAZARD EXPLOSION
To reduce the risk of fire and explosion, the battery
must be replaced in a non-hazardous location.
Use only an approved replacement battery (see
table). Use of an unapproved battery will void
Graco's warranty.
Replace Replace Replace Battery Battery Battery
1. Unscrew cable from the back of the reed switch
assembly.
2. Remove the cable from the two cable clips.
30
All manuals and user guides at all-guides.com
Battery
Battery
HAZARD HAZARD
3. Remove the DataTrak module from the bracket.
Take the module and attached cable to a
non-hazardous location.
4. Remove the two screws on the back of the
module to access the battery.
5. Disconnect the used battery and replace it with
an approved battery.
Approved Approved Batteries Approved
Energizer® brand alkaline #522
Varta® brand alkaline #4922
UltraLife® brand lithium #U9VL
Duracell® brand alkaline #MN1604
Batteries Batteries
3A3489E