Prepare; Washing; Spin-Dry; Rinsing - Saturn ST-WK 7601 Instruction Manual

1.Prepare

– The machine should be placed on flat ground.
– Plug the cord to the mains.
Lay down the overflow hose into a
– Use the water hose to connect the water tap to the water inlet, or open the wash tank lid and fill the
water no less than 35 L.
– According to the material and weight of cloth, adjust the level of water, but do not exceed МАХ level
mark.

2.Washing

– Put the clothes and correct amount of detergent into the tub.
– Set the wash-drain switch to strength or tender mode according to the material and weight of clothes.
– Set the wash timer knob to the proper position and start washing.
– In case the laundry stuck, add some water to the tank, but do not exceed МАХ level mark.
– After wash, set the wash-drain switch to the drain position to drain off water.

3.Spin-dry

– After drain off water, put the clothes to the right spin-tub, evenly distributing them.
– Centrifuge is designed to spin 3 kg of dry laundry.
– Put down the safety lid and push it down.
– Close the inner lid (18), then close the outer lid (10).
– Set the spin-dry timer to the proper time according to the type and weight of the clothes.

4.Rinsing

– After spinning as the spin-dry tub finally stops, open the lids, take out the clothes to the washing tub and
prepare to rinse.
– Besides no more putting the detergent, the rinsing process have no difference with the washing process.
– After rinsing repeat the procedure of spin-drying.
– After wash and rinse, set the wash-drain switch to the drain position to drain off water.
bath-tub.
Never put your hands into the spin
dry tub which is still in rotation, to
avoid accidents even if the spin-
dry tub rotate very slowly, pay
special attention to children.
Never wash the textile, which
contain volatile materials. In such
case, the machine might be
damaged or water might be
blocked to drain out.
When washing, the water temperature should be no more than 60˚С, otherwise it
may damage components.
17
The timer should be
turned clockwise.
When abnormal
sound or movements
are observed during
operation, stop the
machine as soon as
possible.