Pioneer PDP-433MXE Service Manual page 173

CONNECTION PANEL
8Ω ~16Ω
R
SPEAKER
+ –
1
Plasma Display [PDP-433CMX/PDP-433MXE]
Section
The plasma display is provided with 2 video input
connectors, 1 video output connector, audio input/output
jacks and speaker terminals.
There are also CONTROL IN/OUT jacks for connection of
PIONEER components with the Î mark.
When this video card is installed on a plasma display, an
additional three sets of video input connectors are provided
(total five), together with one additional video output
connector (total two).
1
SPEAKER (R) terminal
For connection of an external right speaker.
Connect a speaker whose impedance is 8 -16 Ω.
2
CONTROL IN/OUT (monaural mini jacks)
For connection of PIONEER components that bear the
Î mark. Making CONTROL connection enables control
of the plasma display as a component in a system.
3
COMBINATION IN/OUT
DO NOT MAKE ANY CONNECTIONS TO THESE
TERMINALS.
These terminals are used in the factory setup.
4
RS-232C
DO NOT MAKE ANY CONNECTIONS TO THIS
TERMINAL.
This terminal is used in the factory setup.
CONTROL COMBINATION RS-232C
IN OUT
IN OUT
2 3 4
PDP-433CMX, PDP-433MXE
AC INLET
- =
INPUT1
(ON SYNC)
OUTPUT
G B
ANALOG RGB (ANALOG RGB)
5 6
5
INPUT1 (mini D-sub 15 pin)
For connection of components that have RGB or
component output jacks such as a personal computer,
DVD player, or external RGB decoder. Make sure that
the connection made corresponds to the format of the
signal output from the connected component.
6
OUTPUT (INPUT1) (mini D-sub 15 pin)
Use the OUTPUT (INPUT1) connector to output the
video signal to an external monitor or other component.
Note: The video signal will not be output from the
OUTPUT (INPUT1) connector when the main power of
this display is off or in standby mode.
7
INPUT2 (BNC jacks)
For connection of components that have RGB or
component output jacks such as a personal computer,
DVD player, or external RGB decoder. Make sure that
the connection made corresponds to the format of the
signal output from the connected component.
8
Synchronizing signal impedance selector switch
Depending on the connections made at INPUT2, it may
be necessary to set this switch to match the output
impedance of the connected component's
synchronization signal.
When the output impedance of the component's
synchronization signal is above 75 Ω, set this switch to
the 2.2 kΩ position.
8Ω ~16Ω L
SPEAKER
+ –
~
INPUT2 AUDIO
(H/V SYNC)
R HD VD INPUT OUTPUT
(INPUT1/2)
75 2.2
Ô
Ω
kΩ
7 89 0
173