Canon Racer 539 Hawk Assembly Instructions

Racer 539 Hawk: Assembly Instructions
http://www.canon.com/c-park /en/
Assembly Instructions
Tools
Scissors, glue, ruler, tweezers, pencil
[Caution] Glue, scissors and other tools may be dan-
!
gerous to young children so be sure to keep them out of
the reach of young children.
Mountain fold (dotted line)
Make a mountain fold.
Valley fold (dashed and dotted line)
Make a valley fold.
Scissors line (solid line)
Cut along the line.
Cut in line (solid line)
Cut along the line.
Points to note when making the glider
Try to avoid bending the parts when you cut them out.
Align the parts
against a ruler to fold them.
If any of the cut out parts are bent, this will seriously
affect the glider's performance. Therefore, be sure to
keep all parts perfectly flat till you join them up. For
the wings, stabilizer and other parts, use a ruler to
give you a proper straight edge to make your folds.
When assembling the parts, follow the assembly in-
structions and use the parts in the order given.
When sticking surfaces together, spread the glue evenly
and stick the parts together quickly and line up the
edges cleanly. While the glue is drying, put the fuse-
lage inside a sheet of paper and then press it down with
a book or similar in order to get a nice, straight finish.
C enter line
When sticking the right and left wings together, make
sure that the center line is not off center.
- 1 -
Rub with pencil or scissors
to flatten out.
Flatten the uneven surface.
C ross section of the fuselage
To glue the wings flush onto the fuselage, use a pencil
or scissors to flatten out the part where the wings at-
tach to the fuselage.
Dihedral angle
To give the wings an angle, bend along a straight
ruler. (Refer to the assembly instructions for details on
what degree of angle to use.)
Arrow points forward.
Make sure that the center line of
the wings matches up exactly
Arrow points forward.
with the center line of the fuselage.
Also attach the horizontal stabilizer firmly.
Attach the wings and horizontal stabilizer carefully so
that their center lines match up exactly with the center
line of the fuselage.