Electrical And Water Pressure Requirements - Whirlpool WDC1070 User Manual

Important:
Please retain the four sets of installation kit for future use, when
moving the washer.

2.2 Electrical and water pressure requirements

Please ensure the electric connection is properly
grounded.
Please do not remove the ground connection
Please do not use adapter or Ts (3-pin plug adapter)
Please do not use an extension cord.
Not following this guide may cause fire or lead to
electrical shock and harm lives.
Important Notice
If the electrical cable is spoilt, please contact Whirlpool, Whirlpool's
local agent or qualified personnel for replacement. Please refer to
Whirlpool website for contact numbers.
3. A 220V/ 60Hz/ 20 amp power socket that comes with fuse wire.
Dedicated power supply, enhanced safety wire and circuit breaker are
recommended. Please engage a qualified electrician to install.
1. A 2-pin plug is provided with each washer: the plug
complies with the standards in your country, to be
connected to a power socket that complies to the standards. Please
ensure a good functioning 20A 2-pin socket is
used with the plug.
2.
Check the 220V electrical socket and ensure it
meets the voltage requirement labeled on the
provided cable.
WARNING
Electrical Shock Hazard
7