Table of Contents
Advertisement
Electrical Requirements
A 120 V, 60 Hz, AC-only, 15 or 20 A, fused electrical supply is
■
required. A time-delay fuse or circuit breaker is
recommended. It is recommended that a separate circuit
breaker serving only this appliance be provided.
This washer is equipped with a power supply cord having
■
a 3 prong grounding plug.
To minimize possible shock hazard, the cord must be plugged
■
into a mating, 3 prong, grounding-type outlet, grounded in
accordance with local codes and ordinances. If a mating
outlet is not available, it is the personal responsibility and
obligation of the customer to have the properly grounded
outlet installed by a qualified electrician.
If codes permit and a separate ground wire is used, it is
■
recommended that a qualified electrician determine that
the ground path is adequate.
Do not ground to a gas pipe.
■
Check with a qualified electrician if you are not sure the
■
washer is properly grounded.
Do not have a fuse in the neutral or ground circuit.
■
20
Installation Instructions
WARNING
Excessive Weight Hazard
Use two or more people to move and install washer.
Failure to do so can result in back or other injury.
NOTE:
To avoid floor damage, set washer onto cardboard
before moving it.
1.
Move washer
48"
(1.2 m)
It is necessary to remove all shipping materials for proper
operation and to avoid excessive noise from washer.
Move washer to within 48" (1.2 m) of its final location. It must
be in a fully upright position.
2.
Remove transport bolts from
washer
Loosen bolts with a 3/8" (10 mm) wrench. Once the bolt
is loose, wiggle and completely pull out the bolt and
shipping plug.
Advertisement
Table of Contents
