Table of Contents
Advertisement
Resistance values in orms ( ).
V: Voltmeter or oscilloscope
(r.m.s. or peak reading)
Input resistance :
1 M
Input capacitance :
200 pF
Frequency range : 15 Hz to 1 MHz and d.c. respectively
Note: Appropriate measures should be taken to obtain the correct value in case of non sinusoidal waveforms.
The measuring instrument is calibrated by comparing the frequency factor of
of
from the ideal curve as a function of frequency.
TOUCH CURRENT =
/ 500 (peak value).
The potential at any point (TOUCH CURRENT) expressed as voltage
The part or contact of a TERMINAL is not HAZARDOUS LIVE if:
a) The open-circuit voltage should not exceed 35 V (peak) a.c. or 60 V d.c. or, if a) is not met.
b) The measurement of the TOUCH CURRENT shall be carried out in accordance with IEC 60990, with the measuring network described in Annex D of this standard.
The TOUCH CURRENT expressed as voltages
- for a.c. :
= 35 V (peak) and
- for d.c. :
= 1.0 V
Note: The limit values of
= 0.35 V (peak) for a.c. and
>> terms and conditions
TOSHIBA WEB-ZEUS
Copyright © 1995-2011 TOSHIBA Corporation, All Rights Reserved.
with the solid line in figure F.2 of IEC 60990 at various frequencies. A calibration curve is constructed showing the deviation
and
does not exceed the following value:
and
, does not exceed the following values:
= 0.35 V (peak);
= 1.0 V for d.c. correspond to the values 0.7 mA (peak) a.c. and 2.0 mA d.c.
>> privacy policy
Advertisement
Table of Contents
