Pxga Standard Grille - Friedrich ZONEAIRE SELECT PZE07K3SA Service & Parts Manual

PXGA Standard Grille

PXGA Standard Grille
Installation Instructions
1. Remove.the.center.support.and.weatherboard.if.still.installed.in.
the.sleeve.
2. Insert.six.plastic.grommets.into.the.grille.openings.from.the.outside.
of.the.grille.as.shown.in.Figure.13.
3. Insert.two.#8.x.⅜".sheet.metal.screws.(provided).in.the.top.two.
outside. edge. plastic. grommets,.and.tighten.them. half. way. into.
the.grommets.
4. Grasp. the. grille. by. the. attached. plastic. handles.. . Position.
it. with. the. condensate. drain. knockouts. facing. down..
.
From. inside. the. building,. maneuver. the. grille. through. the. wall.
sleeve. and. pull. toward. you. until. the. screw. heads. are. inserted.
into.the.keyhole.slots.at.the.top.of.the.wall.sleeve...Tighten.the.
two.screws.completely.
Figure 13
Standard Grille
WALL SLEEVE
Quantity
1
6
6
35
12
INSTALLATION
PXGA Standard Grille
Description
Stamped Aluminum Grille
Plastic Grommets
#8 x ⅜" Sheet Metal Screws
5. Insert.the.remaining.screws.into.the.remaining.holes.and.tighten.
securely.
WEATHERBOARD
CENTER SUPPORT
STANDARD GRILLE
WARNING
Falling Object Hazard
Not following Installation Instructions for
mounting your air conditioner can result
in property damage, injury, or death.
WALL
SLEEVE
STANDARD
GRILLE
#8 x 3/8"
SHEET METAL
SCREW
PLASTIC GROMMETS
PLASTIC HANDLES
FRP013