Troubleshooting - Candy CATL 7080 WKI Instruction Manual

3. The whole machine is clean.
Clean the surface of the washing machine and the water in the barrel with a
clean soft cloth. Open the cover for a period of time (about 1 hour) and air dry.
Close the cover again.
Do not spray water directly on the washing machine, or use a thinner, detergent,

kerosene, volatile oil, alcohol, etc.
Specially dirty places can be wiped with a soft cloth dampened with mild soapy
water.
TROUBLE SHOOTING
1. Common non-fault phenomenon
When the was

amount of water flowing out of the drain pipe. This is the residual water when the
factory performance is tested.
In the process of washing or rinsing, water inflow sometimes occurs. This is d

to the automatic replenishment of the water level.
Washing machine setup When the rinsing program is started, no water is

injected. The default rinsing program for the washing machine starts with drainage
and dehydration.
After the dehydrati

the intermittent dehydration set to achieve the dehydration effect.
In the middle of dehydration, water rinsing phenomenon sometimes occurs

because the balance of the clothes is automatically corrected when the clothes are
dehydrated.
Delayed dehydration after the water is finished. This is the default setting of the

hing machine is used for the first time, there may be a small
on starts, the dehydration barrel stops when it is time, which is
16
ue