Sony Handycam DCR-HC37E Operating Manual page 54

Troubleshooting (Continued)
Noises appear and
on the screen.
• The tape was recorded in a TV color system
other than that of your camcorder (PAL).
This is not a malfunction (p. 57).
is displayed on the screen.
• The tape you are playing was recorded on
another device with a 4ch microphone
(4CH MIC REC). Your camcorder is not
compatible with 4ch microphone recording.
Dubbing/Editing/Connecting to
other devices
Pictures output from the camcorder
do not appear on the screen of the
connected device. (DCR-HC45E)
• When attaching the camcorder to the
Handycam Station, close the DC IN jack
cover on the camcorder, and then fully
insert the camcorder into the Handycam
Station in the correct way securely (p. 9).
Time code and other information
appear on the display of the
connected device.
• Set [DISP OUT] to [LCD] while connected
with an A/V connecting cable (p. 40).
You cannot dub correctly using the
A/V connecting cable.
• The A/V connecting cable is not connected
properly. Make sure that the A/V
connecting cable is connected to the input
jack of another device for dubbing a picture
from your camcorder (p. 41).
New sound added to a recorded tape
is not heard.
• Adjust [AUDIO MIX] until the sound is
heard appropriately (p. 33).
54
is displayed Pictures from connected devices are
not displayed correctly.
• The input signal is not PAL (p. 57).
The picture gets disturbed or dark,
or the sounds get distorted. (DCR-
HC45E)
• A/V connecting cables are connected to
both your camcorder and the Handycam
Station. Disconnect one of the A/V
connecting cables.
Connecting to a computer
The computer does not recognize
your camcorder.
• Install the "Picture Motion Browser"
(p. 47).
• The computer may not recognize your
camcorder for a few moments after you
connect it. Wait for a while.
• For DCR-HC45E:
Insert you camcorder into the Handycam
Station correctly (p. 9).
• Disconnect USB devices other than the
keyboard, the mouse, and the camcorder
from the (USB) jack on the computer.
• Disconnect the cable from the computer
and camcorder, restart the computer, then
connect them again correctly.
You cannot install the supplied
software, "Picture Motion Browser,"
on a Macintosh computer.
• You can install "Picture Motion Browser"
only on a Windows computer.