Dialog Telephone Interface Module (Dtim); Pager Communication - GE Simon 60-875 Installation Instructions Manual

Note
Be sure to attach the cover
onto the DTIM before testing
wireless communications.
Simon Security System
4. When you finish testing the system, call the central station to verify that the
alarms were received.
Sensor/User Reporting Codes
Arm or Disarm from:
Panel, Remote Handheld Touchpad or QS1500 Keypad
Keychain Touchpad
Panel Aux Panic
Panel Tamper
Panel Police Panic
Panel Fire Panic
Utility Access Code 1
Utility Access Code 2
Master Code
Access Codes 1-5
Panic Code

Dialog Telephone Interface Module (DTIM)

The following describes the basic steps for testing transmitting range from the DTIM
to the panel. For complete testing instructions, see the DTIM installation instructions.
1. Place the DTIM in the desired location, between 10 and 100 feet (3 and 30
meters) from the panel.
2. Put the panel into sensor test mode (See "Sensor Testing). The panel should sound
1 beep. This indicates good reception from the DTIM to the panel.
Note
If you don't hear a beep, test the DTIM in different locations. Mounting locations should be
limited to areas where the panel responds with a beep. Also, you may not get any beeps if a
neighboring Simon panel is in a downloading session with ToolBox
3. To retest transmitting range after relocating the DTIM (or after a neighboring sys-
tem is finished downloading), you must exit and re-enter sensor test mode.
4. Exit from test mode after determining acceptable locations.

Pager Communication

Use the following table to determine what the numeric message is reporting.
Reports
Phone Test
AC Power Restoral
AC Power Failure
Latchkey
No Activity
Panic Code
Pager Reporting Message
Numeric Message
Reports as User:
0
1-24 (sensor number)
25
26
27
28
28
29
30
31-35
36
®
.
-101 -101
-102 -102
-103 -103
-104 -104
-105 -105
-106 -106
63