Fuel And Evaporative Emissions Control System - HUSTLER FasTrak 48 Operator's Manual

Each transmission's filter is located per Figure 4-4. A
standard oil filter wrench is used to change the filter. The
threads are right handed. Use a Hustler
element only.
IMPORTANT: When washing the mower, direct the spray
away (especially if using a power washer) from the
transmission's seals to prevent water intrusion and to ensure
component performance.
A. Expansion tank
Figure 4-3
A. Filter
Figure 4-4

Fuel and Evaporative Emissions Control System

IMPORTANT: Refer to the Safety section of this manual for
fuel handling safety information.
IMPORTANT: Refer to the engine owner's manual for
additional emissions control information.
605596
approved filter
®
A
B
A
B. Filter guard
The fuel and evaporative emissions control system for this
mower is EPA compliant. Use only Hustler
replacement parts.
Your evaporative emission control system may include
parts such as:
• fuel tanks
• fuel lines
• fuel line fittings
• fuel caps
• carbon canisters
• canister mounting brackets
• carburetor purge port connection
• filters
• vapor hoses
• clamps, control valves
• control solenoids
• electronic controls
• vacuum control diaphragms
• purge valves
• liquid/vapor separator
• other associated components
Modifying or Tampering with the evaporative emissions
control system or the fuel system is prohibited. Federal law
and California State law prohibit the following acts or the
causing thereof:
1. The removal or rendering inoperative by any person
other than for purposes of maintenance, repair,
replacement, of any device or element of design
incorporated into any equipment for the purposes of
emissions control prior to or after its sales or delivery
to the ultimate purchaser or while it is in use, or
2. The use of the equipment after such device or element
of design has been removed or rendered inoperative by
any person.
Use of replacement parts not equivalent to the
original parts may result in system failure and
pose a safety hazard.
The fuel tank is located under the seat platform with the
filler neck and fuel cap located in the left side fender.
Figure 4-5
Park the mower on level ground before filling fuel tank.
Clean the area around the fuel cap before removing the
cap. Remove the fuel cap slowly.
4-3
approved
®
REV K