Table of Contents
Advertisement
Identification plates
384
CLS Shooting Brake: approved aerial positions
Rear roof area
:
Rear wing
;
i
When fitting an aerial on the front roof
area of vehicles with a sliding sunroof,
observe the sweeping range of the roof.
On the rear wing, it is recommended that
you position the aerial on the side of the
vehicle closest to the centre of the road.
Use Technical Specification ISO/TS 21609
(Road Vehicles – "EMC guidelines for fitting
aftermarket radio frequency transmitting
equipment") when retrofitting RF (radio fre-
quency) transmitters. Comply with the legal
requirements for add-on parts.
If your vehicle has fittings for two-way radio
equipment, use the power supply or aerial
connections intended for use with the basic
wiring. Be sure to observe the manufacturer's
additional instructions when installing.
Deviations with respect to wavebands, maxi-
mum transmission outputs or aerial positions
must be approved by Mercedes-Benz.
The maximum transmission output (PEAK) at
the base of the aerial must not exceed the
following values:
Waveband
Short wave (f < 54 MHz)
4 m waveband
2 m waveband
Waveband
Trunked radio/Tetra
70 cm waveband
GSM/DCS/PCS
850/900/1800/1900
UMTS/LTE
The following can be used in the vehicle with-
out restrictions:
R
R
There are no restrictions when positioning the
aerial on the outside of the vehicle for the fol-
lowing wavebands:
R
R
R
R
Identification plates
Vehicle identification plate with vehi-
cle identification number (VIN)
Maximum
transmission
output
100 W
X
30 W
50 W
RF transmitters with a maximum transmis-
sion output of up to 100 mW
mobile phones (GSM/DCS/PCS/UMTS/
LTE)
Trunked radio/Tetra
70 cm waveband
GSM/DCS/PCS
UMTS/LTE
Open the front right-hand door.
You will see vehicle identification plate :.
Maximum
transmission
output
35 W
35 W
10 W
10 W
Advertisement
Table of Contents
