Replacing Bulbs - Mercedes-Benz CLS 2012 Owner's Manual

The interior lighting automatically switches
on if you:
unlock the vehicle
R
open a door
R
remove the key from the ignition lock
R
The interior lighting is activated for a short
time when the key is removed from the igni-
tion lock. You can activate this delayed
switch-off using the on-board computer
( page 242).
Y
Manual interior lighting control
Front overhead control panel
u To switch the rear interior lighting
:
on/off.
| To switch the automatic interior
;
lighting control on/off
p To switch the right-hand reading
=
lamp on/off
c To switch the front interior lighting
?
on/off
p To switch the left-hand reading lamp
A
on/off
To switch the front interior lighting on/
X
off: press the c button.
To switch the rear interior lighting on/
X
off: press the u button.
To switch the reading lamps on/off:
X
press the p button.
Crash-responsive emergency lighting
The interior lighting is activated automatically
if the vehicle is involved in an accident.
To switch off the crash-responsive
X
emergency lighting: press the hazard
warning lamp button.
or
Lock and then unlock the vehicle using the
X
key.

Replacing bulbs

Important safety notes
Xenon bulbs
G
DANGER
Xenon bulbs are under high voltage. If you
touch the electrical contacts of a xenon bulb,
you could suffer an electric shock and be seri-
ously or even fatally injured. For this reason,
do not remove the cover of xenon bulbs.
Do not change the xenon bulbs yourself, but
have them replaced at a qualified workshop.
Bulbs and lamps are an important aspect of
vehicle safety. You must therefore make sure
that these function correctly at all times.
Have the headlamp setting checked regularly.
LED lamps
You can neither replace xenon bulbs nor LED
bulbs. Have LED bulbs changed at a qualified
specialist workshop.
Bulbs and lamps are an important aspect of
vehicle safety. You must therefore make sure
that these function correctly at all times.
Have the headlamp setting checked regularly.
Other bulbs
G
WARNING
Bulbs and lamps can be very hot. You should
therefore allow them to cool down before you
Replacing bulbs
Z
123