Advertisement
B.
In factory mode, enter the Balance menu and change the input source to HD. And
press Pro.-/+ key to select YUVcalbr and press Vol.+ key to activate
C.
Input the pattern as below from a DVD player.
D.
Enter the ADCBal. Menu, and adjust Y/G Offset until the darkest scale is just
obvious. Then adjust Y/G Gain until the brightest scale is just obvious.
E. Input a 10 Gray Scale signal (Timing 35, PATTERN 46, 480I) from Chroma 2327, and
then measure the balance in the center area with a Color Analyzer. (Note: the distance
between the screen and the sensor is 25-30 cm )
F. Adjust the value of R Gain and B Gain until the color coordinate is x=285±15,
y=294±15.
2.
Check the settings in the Factory mode:
Note：a. After the first power-on or downloading, please enter the factory mode and activate
the Reset Data function.
b. Before delivery, enter the factory menu and select All For User in System menu.
And then press Vol.+ key to activate.
Item
GＭ
Reset User D
Language
ServiceM
Reset Data
All For User
Power On
Factory
Source
R Offset
Default
Description
**System menu**
--
Reset user Data
OSD Language
Service menu
Reset all the Data
Set user Data to defaulted values before delivery
Power on mode after the unit is switched up:
( 0—power on directly,
1—remember the last state before powered off,
2—standby after powered on)
Select the method of entering the factory menu
( ON—press PC key to enter directly,
OFF—must input password)
**Balance menu**
Input source selection
R offset for black balance adjustment
15
Advertisement
