9: Adjusting The Speaker Levels And Balance (Test Tone) - Sony STR-DH700 Operating Instructions Manual

9: Adjusting the speaker
levels and balance
(TEST TONE)
You can adjust the speaker levels and balance
while listening to the test tone from your
listening position.
Tip
The receiver employs a test tone with a frequency
centered at 800 Hz.
TV INPUT
SLEEP DMPORT
VIDEO1 VIDEO2
SAT TV
2CH A.F.D.
1 2
4 5
7 8
>10
-
0/10
CLEAR
DISPLAY
,
V/v/B/b
O
RETURN/EXIT
1
Press AMP MENU.
"1-LEVEL" appears on the display.
2
Press or b to enter the
menu.
3
Press V/v repeatedly to select
"T. TONE".
4
Press or b to enter the
parameter.
34
GB
TV ?/1
?/1
AV ?/1
SYSTEM STANDBY
BD DVD
Input
buttons
SA-CD/CD TUNER
MOVIE MUSIC
THEATRE
3
DVD/BD
MENU
6
AUTO CAL
D.TUNING
9
D.SKIP
AMP
MEMORY AMP MENU
ENTER
MENU
TOOLS/
OPTIONS MUTING
TV VOL
MASTER VOL
MASTER
VOL +/–
MENU/HOME
5
Press V/v repeatedly to select
"T. TONE Y".
The test tone is output from each speaker
in sequence as follows:
Front left t Center t Front right t
Surround right t Surround back right*
t Surround back left* t Surround left
t Subwoofer
* You will only hear the test tone from the
– surround back left and right speakers when
surround back speakers are set to "DUAL".
– surround back left speaker when surround
back speakers are set to "SINGLE".
6
Adjust the speaker levels and
balance using the LEVEL menu
so that the level of the test tone
sounds the same from each
speaker.
For details, see "Adjusting the level
(LEVEL menu)" (page 44).
Tips
• To adjust the level of all speakers at the same
time, press MASTER VOL +/–. You can also
use MASTER VOLUME on the receiver.
• The adjusted value is shown on the display
during adjustment.
7
Repeat steps 1 to 5 to select
"T. TONE N".
You can also press any input buttons.
The test tone turns off.
When a test tone is not output
from the speakers
• The speaker cords may not be connected
securely.
• The speaker cords may have the short-circuit
problem.
Note
The test tone does not work when ANALOG
DIRECT is selected.