Table of Contents
Advertisement
Operating the dishwasher
Time display (19)
The running time of a program is shown
in hours and minutes in the time display
before a program is started. During a
program the time left until the end of the
program is displayed. The "Time left"
indicator light next to the time display
lights.
The time displayed may vary with the
same program. This is due to the water
inlet temperature at each intake and the
load size being washed.
When the dishwasher is first turned on
the display shows an average time for a
cold water intake.
Times shown in the program chart refer
to normal loads and average tempera-
tures.
Each time a program is run the elec-
tronic unit takes into account the new
conditions and calculates the time re-
quired. This figure is shown in the time
display.
32
At the end of a program
A program has finished when the "End"
indicator light is on in the program
sequence display (15) and a "0" shows
in the time display (19).
The indicators illuminate for the se-
lected program just finished and any
additional functions which were
chosen.
These will go out when the dishwasher
door is opened.
The dishwasher can now be opened
and unloaded (see "Unloading the
dishwasher").
If the dishwasher is left closed, the fan
will continue for a few minutes to re-
move any remaining moisture.
This process is not part of the program.
Only open the door immediately after a
program has ended if dishes or cutlery
are urgently needed.
^ Always turn the dishwasher off if
another program is not started imme-
diately.
Advertisement
Table of Contents
