Sony DAV-DZ680 Operating Instructions Manual page 29

HDMI SETUP
HDMI RESOLUTION:
CONTROL FOR HDMI:
VOLUME LIMIT:
YC C /RGB(HDMI):
B R
AUDIO(HDMI):
JPEG RESOLUTION:
8
Press X/x to select the setting, then
press .
• [OFF]: The Control for HDMI function is
set to off.
• [ON]: The Control for HDMI function
(page 64) is set to on.
The Setup Display for selecting the speaker
formation appears.
SPEAKER FORMATION
STANDARD
9
Press C/c to select the speaker
formation image as the speakers are
actually positioned, then press
For details, see "Getting Optimal Surround
Sound for a Room" (page 86).
10
Connect the calibration mic (supplied)
to the A.CAL MIC jack on the front
panel.
Set up the calibration mic at ear level using
a tripod, etc. (not supplied).
The front of each speaker should face the
calibration mic, and there should be no
obstruction between the speakers and the
calibration mic.
AUTO
(1920x1080p)
OFF
OFF
ON
OFF
SD
.
Calibration mic
11
Press C/c to select [YES], then press
.
[AUTO CALIBRATION] starts.
Be quiet during the measurement.
Note
• Loud test sounds are output when [AUTO
CALIBRATION] starts. You cannot turn the
volume down. Give consideration to children
and neighbors.
• Before [AUTO CALIBRATION], install the
surround amplifier in the appropriate location. If
you install the surround amplifier in an improper
location, such as another room, proper
measurement will not be obtained.
• The environment of the room in which the
system is installed may affect measurements.
When the measurements differ considerably
from the status of the speaker installation,
perform the speaker settings manually by
following "Settings for the speakers" (page 58).
12
Unplug the calibration mic, press C/c
to select [YES], then press
Quick Setup is finished. All connections
and setup operations are complete.
To quit the Quick Setup
Press DISPLAY in any Step.
.
29
GB