Main Menu Parameters - Shure Legendary Performance AD1 User Manual

Main Menu Parameters

The Main Menu organizes the available transmitter parameters into three categories:
• Radio
• Audio
• Utilities
To change a parameter, press the enter button to enable editing and use the arrow buttons to change values or settings. When finished, press enter to
save.
Radio Menu
Group and Channel
Press the enter button to enable
editing of a group (G:) or channel
(C:). Use the arrow buttons to
adjust the values.
Frequency
Press the enter button once to
edit the first 3 digits, or twice to
edit the second 3 digits.
RF Power
Higher power settings can extend
the range of the transmitter.
RF Output
- On: RF signal is active
- Mute: RF signal is inactive
Tips for Editing Menu Parameters
• To access the menu options from the home screen, press the menu button. Each additional press of the menu button advances to the next menu
screen.
• A menu parameter will blink when editing is enabled
• To increase, decrease or change a parameter, use the arrow buttons
• To save a menu change, press enter
• To exit a menu without saving a change, press menu
Audio Menu
MicOfs
Adjust Mic Offset level to balance mic levels when using
two bodypacks for frequency diversity.
Pad
Adjust the pad to avoid overloading the audio input.
PolarityPos
Selectable polarity assignment for LEMO connector
transmitters:
- Pos: Positive pressure on microphone diaphragm produces posi-
tive voltage on pin 2 (with respect to pin 3 of XLR output) and the
tip of the TRS output.
- Neg: Positive pressure on microphone diaphragm produces neg-
ative voltage on pin 2 (with respect to pin 3 of XLR output) and
the tip of the TRS output.
MuteMode
When enabled, the power switch is configured as a mute
switch for the audio:
- Power switch on: audio signal on
- Power switch off: audio signal muted
Tone
Transmitter will generate a continuous test tone. The tone
can be set to 400 Hz or 1000 Hz.
Level
When enabled, allows for adjustment of the output level of
the test tone.
Utilities Menu
Device ID
Assign a device ID of up to 9 letters
or numbers.
Lock
Locks the transmitter controls and
power switch.
Drop Mark
When enabled, press the enter
button to drop a marker in Wireless
Workbench or Shure ChannelsPlus.
Versions
Displays transmitter information:
- FW: Installed firmware
- HW: Hardware version
- SN: Serial number
Batt Info
Displays battery information:
- Time: Battery runtime
- Health: Percentage of current battery
health
- Charge: Percentage of change
- Cycles: Record of the number of
charging cycles for the installed battery
- Temp: Battery temperature in
Fahrenheit and Celsius
- mAh: Remaining mAh for the installed
battery
Reset All
Restores all transmitter parameters
to factory settings.